QRP Labs QCX – BaMaTech Enclosure

QRP Labs QCX

Since PCB revision 5, a cat port has been incorporated on the PCB. As it’s already a tight fit, I mounted angled pin headers on the underside of the PCB.

QRP Labs QCX

The BaMaTech enclosure was not yet featured with an opening for the cat port. I had to drill a new hole to fit a 3.5mm stereo socket.

QRP Labs QCX

Now that everything is fitted in the enclosure, it’s time to do the final alignment of the QCX. I’m not going to elaborate on this, everything is described in detail in the manual. Just make sure you use a non-conductive anti-static tool when you do this.

Below you can admire the finished result 😉

QRP Labs QCX

Top view with custom splash screen.

QRP Labs QCX

Front view.

QRP Labs QCX

Back view.

QRP Labs QCX

Right side, with added cat port on the bottom left.

QRP Labs QCX

Left side.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.